Chairs needs to be created from a hardcore wood that can support a great deal of weight and withstand numerous years of use. Oak, pine and cherry are popular options. You will need a one inch thick piece for building the seat. Cut the seat in your desired dimension. Most kitchen chairs have a very seat that measures 18×24 inches.
For the legs, you should use pre-cut spindles, or build your own. Use a 2×2 inch board and trim your front two legs exactly the same length, about 18 inches long is standard. Cut a corner two legs 4 feet long. These two legs will likely be used as supports for a corner from the chair.
You can turn the legs with a lathe to round them out and build decorative variations inside the wood before starting to gather. Alternatively, you can buy a thick hardwood dowel and use it for your legs in the chair if you want.
Take the seat and fix the front two legs. You can chisel out a slot for each leg for the underside with the seat if you would like. Create a dowel joint to securely retain the legs in place while avoiding the requirement for screws and nails about the seat surface.
Now you will need to chisel out a slot for the seat on the rear legs. Use a hammer and chisel or perhaps a router for those who have one. Make a slot that goes about one-half inch deep in the legs understanding that starts at the exact length in the front two legs.
Measure and visually test the height of the channel with a flat surface using a level when you cut. Test the seat to make sure they fit securely in the slot. When you assemble the seat and back legs, you might want to create another dowel joint and rehearse wood glue to securely support the seat set up. A nail gun can also be just the thing for nailing the seat to the rear legs from behind.
The next step is always to brace the legs. Run a 1×4 inch board around the outside or inside from the legs on the underside from the chair seat. Measure, cut, and attach each board connecting all legs together.
It’s also recommended that you place a diagonal brace piece from each support board to another, creating an octagon appearance. Metal braces will also be sturdy, inexpensive options. Glue everything into place after attaching each bit with screws or even a nail gun. Allow the wood glue setting prior to going further.
Now you’re ready attach a brace throughout the top of the chair, connecting both back legs. Work with this piece of wood for a time and test out your hand at some planning skills. Plane out about one-half inch from the wood to generate a comfortable place for your time for rest.
You may want to do the same to a few boards to get a ladder back chair. If you want to use spindles for the rear, simply order a good wood dowel that will fit the rest of one’s wood. Drill holes within the top board and chair seat, use wood glue, and assemble the chair back.
After everything is dry, your chair ought to be ready for many years of quality use.
